Chapter 1 Preparation — About your projector
ENGLISH - 39
f The <DIGITAL LINK IN/LAN> terminal and the <LAN> terminal equipped on the projector as standard are connected inside of the projector
when the [NETWORK] menu → [ETHERNET TYPE] is set to [LAN & DIGITAL LINK]. Do not directly connect the <DIGITAL LINK IN/
LAN> terminal and the <LAN> terminal using a LAN cable. Construct the system so that it is not connected to the same network via the
peripherals such as the hub or the twisted-pair-cable transmitter.
f The DIGITAL LINK signal is output only when a display device (projector or at panel display) that corresponds to any of the following is
connected to the <DIGITAL LINK OUT> terminal.
g Panasonic Connect Co., Ltd. display device supporting the DIGITAL LINK input
g Display device installed with the Panasonic Connect Co., Ltd. Function Board supporting the DIGITAL LINK input
f When the [DISPLAY OPTION] menu → [SLOT IN] → [DIGITAL LINK OUT] is set to [ENABLE] and the projector is in projection mode, the
DIGITAL LINK signal (including the audio signal) input to the <DIGITAL LINK IN/LAN> terminal is output from the <DIGITAL LINK OUT>
terminal.
f When the projector is in standby mode, the DIGITAL LINK signal input to the <DIGITAL LINK IN/LAN> terminal is not output from the
<DIGITAL LINK OUT> terminal.
To Next Page
Loading...
