Panasonic PT-REQ12 Series

Chapter 3 Basic Operations — Switching on/o󰀨 the projector
72 - ENGLISH
Initial setting (EDID setting)
Set the main input resolution of the image signal.The setting is reected as the initial setting of [EDID SELECT] for
<HDMI IN 1> terminal / <HDMI IN 2> terminal / <DisplayPort IN> terminal.
After completed the initial setting, you can change the setting from the following menu item.
f [DISPLAY OPTION] menu → [HDMI IN] → [HDMI1] / [HDMI2] → [EDID SELECT]
f [DISPLAY OPTION] menu → [DisplayPort IN] → [EDID SELECT]
1) Press qw to switch the setting.
f The setting will change each time you press the button.
4K
6/8
When "EDID INITIAL SETTING" is changed,
"EDID SELECT" settings for the following
inputs will be changed accordingly.
HDMI1
HDMI2
DisplayPort
INITIAL SETTING
SET
CHANGE
EDID INITIAL SETTING
ENTER
[4K]
Switches to EDID corresponding to the 4K image signal (maximum 4 096 x 2 160 dots, maximum
vertical scanning frequency 60 Hz).
This is EDID supporting HDR (High Dynamic Range).
[2K] Switches to EDID corresponding to the 2K image signal (maximum 1 920 x 1 200 dots) or lower.
2) Press the <ENTER> button to proceed to the initial setting.
Initial setting (time zone)
Set [TIME ZONE] in accordance with the country or region where you use the projector.
After completed the initial setting, you can change the setting from the [PROJECTOR SETUP] menu → [DATE
AND TIME]. The current settings are displayed in [LOCAL DATE] and [LOCAL TIME].
1) Press qw to switch the setting.
+09:00
20XX/01/01
12：34：56
7/8
LOCAL DATE
LOCAL TIME
Please set up a time zone according to the area of your
country or region.
INITIAL SETTING
SET
CHANGE
TIME ZONE
ENTER
2) Press the <ENTER> button to proceed to the initial setting.
Note
f In the factory default setting, the time zone of the projector is set to +09:00 (Japan and Korea Standard Time). Change the setting of the
[PROJECTOR SETUP] menu → [DATE AND TIME] → [TIME ZONE] to the time zone of the region where you use the projector.