197/200
3. Extended Control Command
Start
（STX）
ID Command Parameters END
(ETX)
1 byte 1 byte 1 byte or 2 byte Undefined length 1 byte
ID of the extended control command
ID Hexadecimal
(1 byte)
ID Hexadecimal
(1 byte)
ID Hexadecimal
(1 byte)
ID Hexadecimal
(1 byte)
ID All 00 ID23 17 ID46 2E Group E 84
ID1 01 ID24 18 ID47 2F Group F 85
ID2 02 ID25 19 ID48 30 Group G 86
ID3 03 ID26 1A ID49 31 Group H 87
ID4 04 ID27 1B ID50 32 Group I 88
ID5 05 ID28 1C ID51 33 Group J 89
ID6 06 ID29 1D ID52 34 Group K 8A
ID7 07 ID30 1E ID53 35 Group L 8B
ID8 08 ID31 1F ID54 36 Group M 8C
ID9 09 ID32 20 ID55 37 Group N 8D
ID10 0A ID33 21 ID56 38 Group O 8E
ID11 0B ID34 22 ID57 39 Group P 8F
ID12 0C ID35 23 ID58 3A Group Q 90
ID13 0D ID36 24 ID59 3B Group R 91
ID14 0E ID37 25 ID60 3C Group S 92
ID15 0F ID38 26 ID61 3D Group T 93
ID16 10 ID39 27 ID62 3E Group U 94
ID17 11 ID40 28 ID63 3F Group V 95
ID18 12 ID41 29 ID64 40 Group W 96
ID19 13 ID42 2A Group A 80 Group X 97
ID20 14 ID43 2B Group B 81 Group Y 98
ID21 15 ID44 2C Group C 82 Group Z 99
ID22 16 ID45 2D Group D 83
3.1. LENS CONTROL
■There is a command of the same function to 2.216～2.219.
Hexadecimal 02h *1 B1h 7Ch *2 *3 *4 03h
Remarks STX ID Command Parameters ETX
Parameters(*2)
LENS SHIFT - H LENS SHIFT - V LENS FOCUS LENS ZOOM
Hexadecimal 00h 01h 02h 03h
Parameters(*3)
Slowly Normal Fast HOME POSITION *
Hexadecimal 00h 01h 02h 80h
Parameters(*4)
Right / Up/ Forward/ In / Cancel Left / Down / Backward / Out/ Start
Hexadecimal 00h 01h
Note:
・HOEM POSITION is available only when parameters (2*) is LENS SHIFT H (00h) or LENS SHIFT V (01h).
Response (Callback)
In the period when the command can be accepted
Hexadecimal 02h *5 B3h 7Ch *2 *3 *4 03h
STX ID Command response Parameters ETX
In the period when the command cannot be accepted
Hexadecimal 02h *5 FFh 03h
STX ID Error ETX
Acceptability
SECURITY STANDBY ECO
STANDBY
NO
SIGNAL
SHUTTER FREEZE TEST
PATTERN
REMOTE2 P IN P LENS
HOME
○ × × ○ ○ ○ ○ ○ ○ ○
To Next Page
Loading...
