ENGLISH - 63
2) Press the <ENTER> button.
f The [Keystone] screen is displayed.
3) Press as to select [Corner correction].
4) Press the <ENTER> button.
f The corner correction arrows are displayed on the upper left corner of the projected image.
f The corner to be adjusted switches in order of upper left → upper right → lower left → lower right each time you press
the <KEYSTONE> button on the remote control or the control panel.
5) Press asqw to adjust.
[Corner correction]
Upper left Upper right Lower left Lower right
Note
f The red arrow indicates the direction in which distortion has been corrected while the white arrow indicates the direction in
which distortion has not been corrected.
f The arrow disappears when correction reaches the maximum level.
[Curved correction]
1) Press as to select [Keystone].
2) Press the <ENTER> button.
f The [Keystone] screen is displayed.
3) Press as to select [Curved correction].
4) Press the <ENTER> button.
f The [Curved correction] screen is displayed.
f The item switches in order of [Curved correction X/Y Gain] → [Curved correction X Offset] → [Curved correction Y
Offset] each time you press the <KEYSTONE> button on the remote control or the control panel.
5) Press asqw to adjust the item.
Items Operation Adjustment
[Curved
correction X/Y
Gain]
Press the w button.
The left and right vertical lines will be
bulge.
Press the q button.
The left and right vertical lines will be
dent.
Press the a button.
The top and bottom horizontal lines will
be bulge.
Press the s button.
The top and bottom horizontal lines will
be dent.
Chapter 4 Settings - [Expand] menu
To Next Page
Loading...
