3.6 Structure and Function
• PANHANS - 690|100 - Sliding table saw with tiltable saw blade 0 … 46°
• Slide table length / cutting length: 3200 mm
• Cutting width at rip fence: 1030 mm
• Cutting height at 90°: max. 155 mm
• Cutting height at 46°: max. 105 mm
The machine table has a work surface of 685 mm x 1200 mm.
The drive is provided by a three-phase motor. The speed adjustment is done by V-belt changeover. The speeds
are displayed in the touchscreen positioning control.
The circular saw shaft (30 mm Ø) accepts a saw blade up to Ø 450 mm.
The height and tilt adjustment of the saw is carried out via a positioning control. The double sliding table made
of special aluminium profiles runs on wear-resistant guideways. The cross slide is hooked onto the slide table
and supported by a strong telescopic swivel arm. The cross cut fence has continuous scales and an adjustable
slide. It can be extended to 3200 mm and can be used on both sides of the cross slide.
The rip fence with a quick clamp can be adjusted to any dimension up to 1030 mm.
The main switch is lockable. The motor brake and the star-delta start-up are controlled via a contactor circuit.
3.7 Standard Equipment
• Saw motor with 5.5 kW (7.5 HP)
• 4 speeds with saw blade Ø 450 mm, cutting height 155 mm and saw blade guard
• Cross cut fence on cross slide with mm scale and telescopic pull-out extendable up
to 3200 mm; with 2 pieces of robust and backlash-free sliding flip stops
• Cross cut fence can be used on both sides as angular mitre fence up to 46°
• Table widening 1200 x 600 mm
• Table extension 750 x 655 mm
• Manually adjustable rip fence with cutting width up to 1030 mm
• Electronic, wear-free motor brake
• Saw blade guard with interchangeable wide/narrow insert
• Cross slide with support roller on the outer narrow side
• Operation via control panel with 4.7" touchscreen display
(height and tilt adjustment of the saw unit and speed)
• APA saw blade quick clamping system
• Saw blade Ø 400 mm retractable under the table top
• Suction nozzle Ø 120 mm on machine body, Ø 80 mm on saw blade guard
• Push-button control with electronic soft start for start and stop
• Riving knife 250 … 450 mm, width = 2.5 (Art. No. 0001.0864)
• Open-end spanner SW 17 (Art. No. 0746.0992)
• Wooden push stick type 2391 (Art. No. 3416)
• Allen spanner SW 4 (Art. No. 0345.0741)
• Push handle 2390 (Art. No. 3328)
• Grease gun (Art. No. 0345.0132)
• CE conform and GS tested
To Next Page
Loading...