5.2 Technical Characteristics
• Sliding table saw for trimming, cutting to length, sizing, mitre cutting, etc.
• Dimensionally stable and self-supporting machine body
• Torsion-resistant and finely planed cast iron table top
• Robust and powerful saw unit for precise saw cuts
• Double-guided swivel segments made of grey cast iron
• Double column guide for height adjustment with 2-fold ball bearing mounted, long circular saw shaft for
absolutely smooth running and with remote locking in 50 mm grid
• Smooth-running and maintenance-free double slide table (ball-bearing mounted and extra stable) with
precise and play-free running over the entire length
• Stable and lightweight cross slide, made of steel profiles with a support roller on the outer narrow side
• Cross-cut fence profile with mm scale and magnifying glass, telescopic extension up to 3200 mm, including
two robust and backlash-free flip stops and additional end flip stop
• Manually adjustable rip fence with cutting width 1030 mm to the right of the saw blade
• Fold-down fence for free table surface; safety shut-off bar in case of danger of crushing between
rip fence and slide table
• Table widening 1200 x 600 mm and table extension 750 x 655 mm with pull-out tool drawer
• Control panel with 7" touchscreen display for cutting height, tilt adjustment and speed of rotation
• Motorised height and tilt adjustment via push-buttons
• Tilt range of the saw blade 0 - 46°
• APA saw blade quick clamping system
• Main saw blade speed 3000/4000/5000/6000 rpm
• Protective device can be swivelled away to both sides, guard with interchangeable insert wide/narrow
• Push-button control with electronic soft start (start/stop)
• Electronic, wear-free motor brake
• Saw blade Ø 400 mm retractable under the table
• Extraction port Ø 120 mm on machine body, Ø 80 mm on protective hood
• Slide table, length and width stop profile anodised
• Machine body and swivel arm powder coated
• CE-conform, GS tested
To Next Page