16 Optional Components
16.1 Tele-Digit Cross-Cut Fence
Figure 50: Tele-Digit cross-cut fence
The Tele-Digit is an optional cross-cut fence for PANHANS sliding table saws, which is used instead of the
standard cross-cut fence. A separate measuring system is integrated for each of the two flip stops. This allows
two separate settings of both flip stops. The stop positions are visualised via a wireless digital display. Dust-
insensitive magnetic measuring systems with non-contact scanning are used to determine the position.
16.1.1 Features
• Two non-contact, dust-insensitive magnetic measuring systems
for separate position measurement for each flip stop
• Wireless digital indicator (0.1 mm) with battery operation
• Cutting lengths up to 3000 mm possible
16.1.2 Installation
The Tele-Digit unit is fixed for 90° cuts completely without tools via
the fixing points (F) of the cross slide at the desired position (left or
right on the cross slide).
For angle and mitre cuts in combination with the optional mitre
fences Super Gehrfix I or II, the Tele-Digit cross-cut fence is fixed in
the center of the cross slide. For more information on the Super
Gehrfix I and II, refer to the operating manual of your machine.
To Next Page
Loading...