BA_PH_690-100_EN_10-22.docx
16.4.6 Setting Degrees & Intermediate Degrees
• Loosen the clamping lever (1).
• Then turn the cross-cut fence (L) and approach the desired angular dimension on the grid scale via the
slotted hole for length compensation → Let it engage at the corresponding angular position.
• Tighten the clamping lever (1) again.
16.5 Cross-Cut & Mitre Fence Super Gehrfix II
The combined cross-cut fence and mitre fence "Super Gehrfix II" enables precise angular cuts from 45° to 135°
without changing the dimension set on the cross-cut fence. The angle is set via a digital indicator and the au-
tomatic length compensation via a grid curve made of stainless steel.
To use the Super Gehrfix I it is mandatory to use a saw blade with a thickness of 3.2 mm.
Figure 62: Super Gehrfix II
16.5.1 Features
• Allows infinite adjustment of the mitre angle
• Battery-operated digital indicator included
• Infinitely adjustable and readable to 0.1
• Fixing points for 90° angles at the front and rear of the cross slide
• Automatic length compensation via grid curve
• Setting accuracy: 1/100°
• Can be combined with the standard cross-cut fence or the optional Tele-Digit
• Art. No.: 4303
For mitre cuts, the cross-cut fence (L) must always rest on the support rail (5) .
To Next Page
Loading...