To Next Page

To Previous Page

EVOHD+ Installation Guide

Timed Auto-Arming

(default = disabled) The control panel arms the selected partition every day at the time set. A 60-second Exit Delay (default value) triggers before the partition arms.

It can be cancelled or postponed by entering a valid access code. If zones are open, the control panel arms the partition and considers all open zones as temporarily

bypassed (except 24hr. zones). The control panel transmits the Auto-Arming report code programmed in section [3910]. The control panel will transmit the Late to

Close report code programmed in section [3912]. Enable option [1] in the desired section:

Auto-Arm Timer

Enter the time when the partition should arm in the desired section:

Postpone Auto-Arming

(default = 000) It is possible to postpone auto-arming for a preset amount of time by entering a valid user code during the exit delay. The delay is set by entering a

number between 001 and 255 in the appropriate section. That number represents for how many increments of 15 minutes the arming will be postponed.

Partition 1: [3122] Partition 3: [3322] Partition 5: [3522] Partition 7: [3722]

Partition 2: [3222] Partition 4: [3422] Partition 6: [3622] Partition 8: [3822]

Partition 1: [3101] Partition 3: [3301] Partition 5: [3501] Partition 7: [3701]

Partition 2: [3201] Partition 4: [3401] Partition 6: [3601] Partition 8: [3801]

Partition 1: [3120] Partition 3: [3320] Partition 5: [3520] Partition 7: [3720]

Partition 2: [3220] Partition 4: [3420] Partition 6: [3620] Partition 8: [3820]