Parker 890CD - How To Change a Parameter Value

The Keypad
890CS Common Bus Supply - Frames B & D; 890CD Common Bus Drive and 890SD Standalone Drive - Frames B, C & D Page 8-43
8
9
10
11
A
B
C
D
1
2
3
4
5
6
7
E
How To Change a Parameter Value
You can change the values of parameters stored in the OPERATOR, QUICK SETUP and SETUP menus.
Refer to Chapter 9 for further information.
• View the parameter to be edited and press
to display the parameter’s value.
• Select the digit to be changed (pressing the
key moves the cursor from right to left).
• Use the
keys to adjust the value. Hold the key momentarily to adjust the value marginally, or
hold the key to make rapid changes; the rate of change varies with the time held.
• Press
to return to the parameter display.