Particle Measuring Systems LASAIR II 550L Operator's Manual


Page Page G-2 G-2 LASAIR LASAIR II II Operator’s Operator’s ManualManual
Appendix G: LASAIR II Native Serial CommunicationsAppendix G: LASAIR II Native Serial Communications
ErrorError
A command failed due to other circumstances. The A command failed due to other circumstances. The most likely causemost likely cause
is that the serial interface did not execute the “is that the serial interface did not execute the “
KB 1KB 1
” command to lock-out” command to lock-out
keyboard control, and someone is using the front panel controls. This messagekeyboard control, and someone is using the front panel controls. This message
can also be caused by a parameter out of range.can also be caused by a parameter out of range.
Error --RangeError --Range
The following commands have a parameter out-of- range:The following commands have a parameter out-of- range:
•• TNTN
••
ANIDANID
••
AUTOSTARTAUTOSTART
•• C 10C 10
LASAIR Upgrade InformationLASAIR Upgrade Information
The original LASAIR had a somewhat The original LASAIR had a somewhat terse interface, hence users who want terse interface, hence users who want toto
upgrade their own software must handle the fundamental interface changes. Theupgrade their own software must handle the fundamental interface changes. The
following is a quick list of supported commands from the LASAIR, with notesfollowing is a quick list of supported commands from the LASAIR, with notes
about any differences.about any differences.
The following command is not supported:The following command is not supported:
RR
 Retransmit Retransmit sample sample in in last last group.group.
Commands Supported from the LASAIRCommands Supported from the LASAIR
SSSS
Start SamplingStart Sampling
ESES
End SamplingEnd Sampling
SNSN
Set to continuous samplingSet to continuous sampling
CC
Change/setup command (see additional information below).Change/setup command (see additional information below).
KBKB
Keyboard lockout command. This is retained through aKeyboard lockout command. This is retained through a
power cycle.power cycle.
KGKG
Keyboard lockout until power cycle.Keyboard lockout until power cycle.
TITI
Set sample intervalSet sample interval
TDTD
Set time/dateSet time/date
IDID
Set instrument ID.Set instrument ID.

Particle Measuring Systems LASAIR II 550L Specifications

General

Brand	Particle Measuring Systems
Model	LASAIR II 550L
Category	Measuring Instruments
Language	English