C CommandsC Commands
LASAIR II Operator’s ManualLASAIR II Operator’s Manual
PagePage
G-3G-3
C CommandsC Commands
Supported C CommandsSupported C Commands
C 0 yyC 0 yy Set Date-Year. Two digit yearSet Date-Year. Two digit year
C 1 mmC 1 mm Set Date-MonthSet Date-Month
C 2 ddC 2 dd Set Date-DaySet Date-Day
C 3 hhC 3 hh Set Time-HourSet Time-Hour. Use 24 . Use 24 hour format.hour format.
C 4 mmC 4 mm
Set Set Time-MinuteTime-Minute
C 5 secC 5 sec Set Time--SecondSet Time--Second
C 6 id_stringC 6 id_string Set Instrument IDSet Instrument ID
C 7 numC 7 num Set Number of SamplesSet Number of Samples
C 8 hhC 8 hh Set Sample Time-Hour. Set sample time in order of Set Sample Time-Hour. Set sample time in order of hours, minutes andhours, minutes and
seconds to avoid problems.seconds to avoid problems.
C 9 minC 9 min
Set Sample Time-Minutes. Set sample time in order of hours,Set Sample Time-Minutes. Set sample time in order of hours,
minutes and seconds to avoid problems.minutes and seconds to avoid problems.
C 10 secC 10 sec Set Sample Time-Seconds. Set sample time in order of hours,Set Sample Time-Seconds. Set sample time in order of hours,
minutes and seconds to avoid problems. This commanminutes and seconds to avoid problems. This command returns a Range Errord returns a Range Error
if sec < 6, and min = 0, and hours = 0.if sec < 6, and min = 0, and hours = 0.
C 11 [1/0]C 11 [1/0]
Set Sample Print on/offSet Sample Print on/off
C 12 hhC 12 hh Set Delay Time--Hours. Set delay between samples.Set Delay Time--Hours. Set delay between samples.
C 13 minC 13 min Set Delay Time--Minutes. Set delay between samples.Set Delay Time--Minutes. Set delay between samples.
C 14 secC 14 sec
Set Delay Time--Seconds. Set delay between samples.Set Delay Time--Seconds. Set delay between samples.
C 16 [1/0]C 16 [1/0]
Set continuous (repeat) mode on/off. When turned off, the numberSet continuous (repeat) mode on/off. When turned off, the number
of samples is set to 1.of samples is set to 1.
C 21 chan nameC 21 chan name Set Analog ID Label. Set name for user analog channel 1-4Set Analog ID Label. Set name for user analog channel 1-4
C C 22 22 chan chan minmin Set Analog 4 mA value. Set user analog channel minimumSet Analog 4 mA value. Set user analog channel minimum
engineering unit value.engineering unit value.
C C 23 23 chan chan maxmax
Set Analog 20 mA value. Set user analog channel maximumSet Analog 20 mA value. Set user analog channel maximum
engineering unit value.engineering unit value.
C 24 chan unitsC 24 chan units Set Analog Units. Set name for analog channel units.Set Analog Units. Set name for analog channel units.
C 25 chan [1/0]C 25 chan [1/0]
Enable/disable analog channelEnable/disable analog channel
C 32 hhC 32 hh
Set Purge Delay Time HoursSet Purge Delay Time Hours
To Next Page
Loading...
Need help?
General
