Name: Particle Measuring Systems LASAIR II 550L
Brand: Particle Measuring Systems
Rating: 4 (1 reviews)

To Next Page

To Previous Page



Installing the LASAIR IIInstalling the LASAIR II

LASAIR II Operator’s ManualLASAIR II Operator’s Manual

PagePage

2-52-5

To connect the sample probe directly to the sample inlet:To connect the sample probe directly to the sample inlet:

11 Remove the protective cap from the sample inlet.Remove the protective cap from the sample inlet.

Place the probe adaptor over the sample inlet. Place the probe adaptor over the sample inlet. The adaptor’s internal O-ring willThe adaptor’s internal O-ring will

hold it to the sample inlet.hold it to the sample inlet.

33 Place the sample probe over the adaptor tube. The sample probe’s internal O-Place the sample probe over the adaptor tube. The sample probe’s internal O-

ring will hold it to the adaptor tube.ring will hold it to the adaptor tube.

44 GentlyGently, but firmly, press downward on the , but firmly, press downward on the sample probe until it sample probe until it will not movewill not move

down any down any furtherfurther..

To connect the sample probe to tubing:To connect the sample probe to tubing:

11 Insert the ribbed end of the cylindrical sample inlet aInsert the ribbed end of the cylindrical sample inlet adaptor fully into one enddaptor fully into one end

of the tube.of the tube.

22 Insert the ribbed end of the sample pInsert the ribbed end of the sample probe adaptor fully into the other end robe adaptor fully into the other end of theof the

tube. See Figuretube. See Figure 2-5, “350L and 550L A2-5, “350L and 550L Assembled Sample Probe ssembled Sample Probe end of theend of the

TubTubing,” ing,” on pagon pagee 2-6.2-6.

33 Fit the sample probe over the open end Fit the sample probe over the open end of the sample probe adapter. The sampleof the sample probe adapter. The sample

probe’s probe’s internal O-ring will hold it securely to the adaptorinternal O-ring will hold it securely to the adaptor..