Paytec Eagle - Page 31

31
N The coin is ONLY accepted IF tubes are full (Exact-Change OFF).
Y The coin is ALWAYS accepted (even when tubes are empty).
 Select “Y” for coins that are supposed to fall in tubes.
 Select “Y” for low-value coins, which can be used to pay a vend in Exact-Change.
This option is valid when a key reader is connected.
N The coin is accepted with/without key inserted, following the parameters
previously set.
Y The coin is ONLY accepted IF a key has been inserted in the reader
(Exact-Change condition is ignored).
When the max. credit on key has been reached, coins are not accepted
when trying to recharge the key with more credit.
N Standard setting.
Y The “coin” is accepted as a token (you can configure the system so that
keys cannot be recharged with tokens – see Fn35).
With protocol MDB, the system communicates the VM that the coin
accepted is a token (the value is not given, though). The VM will then
manage the token to confirm a vend.
Here starts the list of coin parameters.
DO NOT MODIFY DEFAULT COIN PARAMETERS.
Coin “diameter”.
DO NOT MODIFY.
Tolerance on coin "diameter".
DO NOT MODIFY.
Coin “thickness”.
DO NOT MODIFY.
Tolerance on coin “thickness”.
DO NOT MODIFY.
Parameter “DLX”.
The measure is taken by “Enable DLXX = Y”.
. DO NOT MODIFY.
Tolerance on parameter “DLX”.
DO NOT MODIFY.
Parameter “Alloy Negative”.
DO NOT MODIFY.
Tolerance on parameter “Alloy Negative”.
DO NOT MODIFY.
Coin No.
1
Exact-Change ?
Coin No. 1
with Cashless ?
Coin No. 1
token ?
Coin No. 1
Diameter: ----
Coin No. 1
D-Diameter: ----
Coin No. 1
D-Thick.Ind.:----
Coin No. 1
D-DLX: ----
Coin No. 1
Thick.Ind.: ----
Coin No. 1
DLX: ----
Coin No. 1
D-AlloyPhase-:---
Coin No. 1
AlloyPhase-: ----