PENKO FLEX2100 - System Information; Hardware and Software Versions; License and Certification Details

FLEX 2100
56
Info 01
Here you find all the hardware and software versions that are installed, the license for this
Flex 2100 and the certified information.
Info:
The information find here is:
- Hardware version (this is the version of circuitboards of the Flex 2100)
- Bootloader version (this is the Bootloader software versio)
- FPGA Videochip version (this is the videochip software version)
- Version (this is the Firmware version)\
- HWID (This is the hardware ID number)
- SFID (this is the software ID number)
- Serial Number (this is the serial number of the Flex 2100)
- MAC Address (this is the MAC address of the Ethernet chip)
- Software update trace counter (this is the number of time a new firmware is updated to
the Flex 2100.
- User program CRC (this is the checksum on the program)
License:
Here you can see what kind of license the Flex 2100 has and here you can also change
the license.
Certified:
Here you can see the certification information for when the Flex 2100 is used as a certified
weigher.