Pentair FLECK 5810 SXT - Regeneration Types

Installer Manual Fleck 5810 - SXT - Installation
46 / 106 Ref. MKT-IM-016 / C - 08.06.2018
5.7. Regeneration types
Metered:
The controller monitors the volume of water used. Once it calculates that system capacity is reached,
a regeneration cycle will be initiated immediately or at a pre-set time.
• Immediate control: The controller measures water usage and regenerates the system as soon
as the system capacity is reached;
• delayed control: The controller measures water usage and regenerates the system, at the
specified regeneration time, after the system capacity is reached. The system capacity is
calculated by subtracting the reserve.
Time clock:
The controller will regenerate based on a set number of operation days.
• Day interval control: The controller will regenerate the system, at the specified regeneration
time, when the number of days since the last regeneration equals the regeneration day override
value;
• day of the week control: The controller will regenerate the system, at the specified regeneration
time, on each programmed active days of the week.