Pentair FLECK 5810 SXT - Optical Sensor Replacement

Installer Manual Fleck 5810 - SXT - Maintenance
Ref. MKT-IM-016 / C - 08.06.2018 89 / 106
9.2.8. Optical sensor replacement
No. Operation
A Remove the controller, see 9.2.2. Controller replacement, page 81.
B Release the optical sensor support (1) by pushing it back and up as shown.
C Release the optical sensor (3) from its support (1) by pressing the clips (2).
D Disconnect the wire from the motor to the optical sensor (4).
E Change the optical sensor (3).
F Reverse above procedure steps to rebuild.