Pentair FLECK 5810 SXT - Software Version (SV); Resetting the Controller; Soft Reset (SR); Hard Reset (HR)

Installer Manual Fleck 5810 - SXT - Programming
Ref. MKT-IM-016 / C - 08.06.2018 73 / 106
6.7.8. Software version (SV)
Note
Shows the version of the software used by the controller.
6.8. Resetting the controller
Note
There are two methods to reset.
6.8.1. Soft reset (SR)
Caution
All the parameters are set to default values, except volume remaining in volumetric
systems and days since last regeneration in time clock systems.
6.8.2. Hard reset (HR)
Caution
All the parameters are set to default values.
G Software version display:
A Press and hold and for 25 seconds while in normal service mode
until SR is displayed.
B Reprogram all parameters in Master programming mode.
A Hold while powering up the unit.
B The display shows HR.
C Reprogram all parameters in Master programming mode.