Pentair FLECK 5810 SXT - Days Override (DO); Regeneration Time (RT)

Installer Manual Fleck 5810 - SXT - Programming
64 / 106 Ref. MKT-IM-016 / C - 08.06.2018
6.5.11. Days override (DO)
Set the maximum number of days between regeneration cycles.
Note
This parameter allows to set the maximum amount of days that the system can stay in
service mode without a regeneration.
Mandatory
In time clock mode the setting of this parameter is mandatory.
Note
Setting the parameter to "OFF" disables this function.
Note
The number of days can be set from OFF, or 1 to 99 days.
Note
This parameter is not displayed for the day of week regeneration.
6.5.12. Regeneration time (RT)
Set the regeneration time.
Note
Regeneration time is the time of the day when regenerations occur for meter delayed
regeneration, time clock regeneration, day of the week regeneration and calendar override
regeneration.
Y Press or to set the days override.
Z Press to validate the selection and move to the next parameter.
AA Press or to set the regeneration time.
AB Press to validate the selection and move to the next parameter.