Pentair FLECK 5810 SXT - Basic Programming; Days Override (DO); Regeneration Time (RT); Feed Water Hardness (H)

Installer Manual Fleck 5810 - SXT - Programming
54 / 106 Ref. MKT-IM-016 / C - 08.06.2018
6.4. Basic programming
Note
Menus are displayed in a defined and incremental order.
Note
If no button is pressed for 5 minutes in the Programming mode (basic or master mode), or
if there is a power failure, the controller returns to Service mode and changes made are not
saved.
Mandatory
In order to save the new settings in the programming mode, it is necessary to go through all
the parameters.
6.4.1. Days Override (DO)
Determine the maximum number of days of operation without regeneration.
6.4.2. Regeneration time (RT)
Determine the time of regeneration.
6.4.3. Feed Water Hardness (H)
Determine the feed water hardness in °TH.
A Press and simultaneously for 5 seconds to enter the menus
sequence.
B Select the number of days of Override with and .
C Press to validate the selection and advance to the next parameter.
D Adjust the regeneration time with and .
E Press to validate the selection and advance to the next parameter.
F Adjust the water hardness with and .
G Press to validate the selection and advance to the next parameter.