Installer Manual Fleck 5810 - SXT - Operation
78 / 106 Ref. MKT-IM-016 / C - 08.06.2018
8.2. Recommendations
• Use only regeneration salts designed for water softening upon regulation EN973;
• for optimal system operation, the use of clean salt and impurities free is recommended (for
example salt pellets);
• the sanitizing process (both with liquid and electrochlorination) may introduce chlorine
compounds which may reduce the lifetime of the ion exchange resins. Refer to the technical
guides for resins in common use, providing necessary checks on the system.
8.3. Manual regeneration
Mandatory
The controller must be in service in order to enable this procedure.
8.3.1. Manual delayed regeneration
Note
Not available in volumetric immediate regeneration mode.
A Press once for delayed regeneration.
→ The regeneration starts at the programmed regeneration time.
See chapter 6.5.12. Regeneration time (RT), page 64.
→ The service icon flashes.
Note
To cancel: press again. The service icon stop flashing.
8.3.2. Manual immediate regeneration
A Press and hold for 5 seconds to initiate immediate manual regeneration regardless from
the programmed regeneration control type.
8.3.3. To advance regeneration cycles
A Press to pass to the next regeneration cycle.
To Next Page
Loading...
