Pentair FLECK 5810 SXT - Unit Capacity (C); Filter Capacity (V)

Installer Manual Fleck 5810 - SXT - Programming
Ref. MKT-IM-016 / C - 08.06.2018 61 / 106
6.5.7. Unit capacity (C)
Set the unit capacity.
Note
The unit capacity parameter is only available if the regeneration control type has been
programmed for volumetric regeneration.
Note
The unit capacity can be set from 1 to 999,9 x 1000 °TH*L, g as CaCO
3
equivalent.
6.5.8. Filter capacity (V)
Set the filter capacity.
Note
The filter capacity parameter is only available if the regeneration flow has been
programmed for filter.
Note
The filter capacity can be set from 1 to 999.9 x 1000 L.
M Press or to set the unit capacity.
N Press to validate the selection and move to the next parameter.
O Press or to set the filter capacity.
P Press to validate the selection and to move the next parameter.