Pentair FLECK 5810 SXT - Day of the Week (Dn, N = 1 to 7)

Installer Manual Fleck 5810 - SXT - Programming
66 / 106 Ref. MKT-IM-016 / C - 08.06.2018
6.5.13.3 For regeneration type O-UF and O-DF
Note
The regeneration cycles are identified as C1 to C20.
Mandatory
The last cycle must be set with LC.
6.5.14. Day of the week (Dn, n = 1 to 7)
Set the active days for regeneration.
Note
The day of week parameter is only available if day of the week mode has been set in
regeneration control type selection.
Note
The current day is defined from D1 (Monday) to D7 (Sunday).
Note
By default, every Dn is set to OFF.
AE Press or to set the type of regeneration cycle.
AF Press to validate the selection.
AG Press or to set the duration of this cycle.
AH Press to validate the selection and move to the next regeneration
cycle.
AI Repeat AE to AH as needed.
AJ Select LC.
AK Press to validate the selection and to move to the next parameter.
In this example: 
C1 = Rapid Rinse
for 30 min
AL Press or to set "ON" or "OFF" to set the day as a regeneration day.
AM Press to validate the selection.
AN Repeat AL to AM until D7 is set.
AO Press to validate the selection and move to the next parameter.