Pentair FLECK 5810 SXT - Meter Pulse (K); Time Based Relay Setting (RE)

Installer Manual Fleck 5810 - SXT - Programming
68 / 106 Ref. MKT-IM-016 / C - 08.06.2018
6.5.17. Meter pulse (K)
Set the meter pulse for a non-standard flow meter.
Note
The meter pulse parameter is only available if the Gen option has been set in flow meter type
selection.
Note
The meter pulse can be set from 0,1 to 999,9.
6.5.18. Time based relay setting (RE)
Select the relay setting.
Note
The relay can bet set upon a time base (tb) or a flow base (Fb). Only one method can be used
at a time.
Note
If set to tb, the controller will enable and disabled the relay output on set times.
6.5.18.1 Relay start time (ST)
Set the relay start time.
Note
This option is available only if time based relay (RE) is set to tb.
Note
The relay activation can be set from minute 0 of the regeneration to the total regeneration
duration minus 1 minute.
AT Press or to set the meter pulses per unit of volume.
AU Press to validate the selection and move to the next parameter.
AV Press or to select between tb and OFF.
AW Press to validate the selection and move to the next parameter.