Pentair FLECK 5810 SXT - Entering Master Programming Mode; Display Format Mode (DF)

Installer Manual Fleck 5810 - SXT - Programming
Ref. MKT-IM-016 / C - 08.06.2018 59 / 106
6.5.2. Entering master programming mode
6.5.3. Display format mode (DF)
Select the unit of measure.
Options:
• GAL: U.S. Gallons and 12-Hour AM/PM;
• Ltr: litres and 24-Hour.
ET Relay end time
Relay start
time +1 to
regeneration
duration
Minute Only displayed for tb relay setting.
VR
Flow based relay
setting
OFF - Fb Flow based
Only displayed if time based relay (RE)
is set to OFF.
VO Volume interval
1 to the total
capacity
Litre
Only displayed for Fb relay setting.
TO Relay time ON 1 to 7200 Minute
A Press and hold or until the programming icon replaces the service
icon and the parameter display reads TD.
B Set the time to 12:01 PM with or .
C Press to validate the selection and return to the service mode, or wait
for 10 seconds.
D Press and hold and until the programming icon replaces the
service icon and the display format screen appears.
E Press or to select the unit.
F Press to validate the selection and move to the next parameter.
Parameter Options Definition Note