Installer Manual Fleck 5810 - SXT - Programming
70 / 106 Ref. MKT-IM-016 / C - 08.06.2018
6.5.19.1 Relay volume interval (VO)
Set the relay volume interval.
Note
This option is available only if flow based relay (VR) is set to Fb.
Note
The relay volume interval can be set from 1 to the initial volume capacity.
6.5.19.2 Relay time ON (TO)
Set the relay time ON.
Note
This option is available only if flow based relay (VR) is set to Fb.
Note
The relay time ON can be set from 1 to 7200 minutes.
6.6. Filter programming
To use the valve as a filter, in the master programming mode, set the regeneration flow mode (RF) to
filter (FLtr). The controller will let set only the steps necessary to the filter mode, which are:
regeneration control type (CT), filter capacity (V), reserve selection (RS), days override (DO),
regeneration time (RT), backwash (BW), rapid rinse (RR), day of week (Dn), current day (CD), flow
meter type (FM), meter pulse (K), time based relay setting (RE) and flow based setting (VR).
BD Press or to set the relay volume interval.
BE Press to validate the selection and move to the next parameter.
BF Press or to set the relay time ON.
BG Press to validate the selection and exit the master programming
mode.
To Next Page
Loading...
