Unpacking and Installation . 41
Frontier IR instruments can operate on electricity supplies of 50 Hz or 60 Hz and in the 100 V
to 230 V range without any adjustment.
1. Fit the molded socket of the power cable into the electrical supply inlet (Figure 13) of
the instrument.
Figure 13 Electrical supply inlet
2. Switch on the power at the supply.
3. Switch on the instrument at the switch above the supply inlet.
I is on and O is off.
After a short diagnostic check, which takes about 2 minutes and is described in
Appendix 2:
Instrument Self-Checks
on page 90, your instrument will be ready to communicate with the
PC.
To Next Page
Loading...
