XF Camera System Manual |
Instructions for changing the focusing screen
Changing the focusing screen is not a trivial task, and should only be done by
an experienced person or a Phase One Service Center.
Note: There are two dierent procedures for changing the focusing screen,
depending on which version of the XF Camera Body you have.
XF Camera bodies with a serial number up to RA003841 require that the
focusing screen is changed through the mirror box, while models produced
after Nov. 9th 2016 with serial number higher than RA003841 have the
focusing screen changed from the top of the XF Camera Body.
Please check the serial number on the bottom of your XF Camera Body, and
proceed to the section below that matches your camera version.
WARNING:
Since the focusing screen’s surfaces are soft and easily damaged, handle them
with care. Never touch the surface with bare fingers. Should dust settle on it,
simply blow it away with a blower. If the focusing screen needs cleaning, send
it to the nearest authorized Phase One Service Center, instead of attempting
to clean it yourself, as it is very delicate. Do not touch the mirror in any way, as
its surface is easily damaged.
To Next Page
Loading...
Need help?
General
