l
Place the unit in an accessible location to allow for proper venting of the equipment and to
facilitate servicing.
l
Do not use an adapter plug on the line cord or wall outlet.
l
Do not remove the ground pin from the line cord.
l
Place the printer so the AC power adapter is close to an easily accessible wall out let. DO NOT
use a wall outlet controlled by a wall switch or one that is shared with other equipment.
l
DO NOT route the power cord over sharp edges or trap it between pieces of furniture. Make
sure there is no strain on the power cord.
l
DO NOT route the DC power cord that plugs into the printer over sharp edges or trap it between
pieces of furniture. Make sure there is no strain on the DC power cord.
l
Make sure the area in front of the wall outlet into which the AC adapter is plugged is free from
obstruction.
l
To reduce the risk of fire or electrical shock, DO NOT attempt to remove covers or disassemble
the control panel or its base. The cabinet encloses hazardous parts. If you should drop or
otherwise damage the unit, call Pitney Bowes.
l
Before clearing a stoppage, be sure machine mechanisms come to a stop.
l
When removing stalled material, avoid using too much force to protect against minor personal
injury and damaging equipment.
l
To prevent overheating, do not cover any vent openings.
l
Operation of this equipment without periodic maintenance will inhibit optimum operating
performance and could cause the equipment to malfunction. Contact your machine supplier for
required service schedule.
l
Read all instructions before attempting to operate the equipment.
l
Use this equipment only for its intended purpose.
l
Always follow the specific occupational safety and health standards for your workplace.
l
Use only Pitney Bowes approved direct thermal label media.
l
Always follow the specific occupational safety and health standards prescribed for your
workplace.
Caution:
In case of an ink spill, leaking ink or excessive ink accumulation, immediately disconnect
the power cord from the wall plug and contact Pitney Bowes. Customer Service Representatives
are available Monday through Friday, 8:30 am - 5:00 pm.
It is certified that the system complies with all applicable Directives of the European Union.
For a formal Declaration of Conformity please contact Compliance Engineering. Contact information is
given in this guide or on a separate document supplied with your system.
15 • Product Information
Pitney Bowes User Guide June 2022 117
To Next Page
Loading...
