Planet WNAP-6325 - System Configuration Settings; Default Device IP Settings

User Manual of WNAP-6325
-55-
5.1.20 SNMP
Click “Operation Mode”  “AP Router” or “Wireless ISP” and then enter the “SNMP” by clicking the Setup
button next to it. This section allows you to configure the SNMP.
Figure 5-32 SNMP Settings
Object Description
 SNMP
Enable or disable the SNMP service.
 Read Community
Enter a Read Community name for verification with the SNMP manager
for SNMP Read requests.
 Write Community
Enter a Write Community name for verification with the SNMP manager
for SNMP Write requests.
 Trap IP 1
Enter the Trap IP address.
 Trap Community
Enter an SNMP Trap Community name for verification with the SNMP
manager for SNMP Trap requests.