10 Introduction Planmeca Emerald User Manual
Cleaning the System
For intraoral scanning systems only.
Protect the keyboard with a disposable barrier.
Cleaning Cycle: Before and after each use, clean all areas of the Planmeca System.
Warning: Before and after each use, follow these instructions to disinfect the Planmeca System.
Do not substitute any other cleaning solution or procedure. Under no circumstances should you use any
paint thinner, solvents, or harsh chemicals. Use only a non-woven sponge or pre-moistened germicidal
cloths when cleaning the Planmeca System.
1 Using a clean, non-woven sponge that has been saturated with a hospital grade, TB-rated germicide or pre-
moistened germicidal cloths, apply the germicide to the entire surface of the scanner base, scanner holder,
mouse, mousepad, and any other surfaces that you touch that were not covered by a disposable barrier. Do not
spray the germicide directly on the items and do not submerge the scanner or mouse in the germicide.
2 Follow the germicide manufacturer’s instructions.
Cleaning the Scanner Cover
The rubber part of the scanner should be removed once a month for cleaning. This part is often referred to as the
“sleeve”, “boot”, or “cover”.
1 Start on the bottom of the cover and ip/roll it upwards.
2 Flip/roll the bottom of the top of the scanner.
3 Continue rolling the cover upwards until you can pull it o.
4 Clean the cover and base with germicide as stated in “Cleaning the System” above.
5 Ensure the cover is right-side-out and slide it back onto the scanner.
To Next Page
Loading...
Need help?
General