Scanning Safety
Warning: Failure to adhere to all safety warnings may result in personal injury, equipment damage, or data loss.
Do not use the Planmeca products for any purpose other than its intended and labeled use.
To prevent electrical shock, do not open any sealed or user restricted access panels or connectors.
In case of emergency unplug the computer power cord from the wall or from the computer.
Do not make any unauthorized repairs or modications to the system software or hardware. This includes installing unauthorized
software on the host computer system or altering or bypassing any safety switches or mechanisms. Changes or modications not
expressly approved by Planmeca could void the user’s authority to operate the equipment and/or void the warranty.
Do not install or operate the Planmeca products in an environment where an explosion hazard exists, e.g., high oxygen area.
Comply with all applicable regulations when disposing of waste materials from the Planmeca products.
Do not attach any equipment or devices to the Planmeca products unless their use has been specically authorized by Planmeca
or E4D Technologies.
Medical electrical equipment requires special precautions regarding EMC (Electromagnetic Compatibility). The Planmeca products
must be installed and placed into service according to the EMC information provided in the documentation that accompanies the
Planmeca products.
Portable and mobile RF (Radio Frequency) communications equipment can aect medical electrical equipment.
The wireless components in the Planmeca products may be interfered with by other equipment, even if the other equipment is
fully compliant with CISPR (International Special Committee on Radio Interference) emission requirements.
When possible, electrical equipment should not be used when adjacent to other electrical equipment. If adjacent use is necessary,
the equipment should be observed to verify normal operation in the conguration in which it will be used.
When connecting the Planmeca components, use only the cables supplied with the products. Failure to do so may result in
increased electromagnetic emissions or reduced immunity to external electromagnetic emissions.
If you suspect equipment malfunction or failure, discontinue using the Planmeca products and contact Technical Support
immediately. Do not attempt to make any repairs on the Planmeca products.
Read and comply with all safety, warning, and instructional labels on the Planmeca products.
Avoid eye exposure while using the scanner. LEDs contained in this device pulse at a frequency that may elicit
reactions in sensitive individuals. These reactions may include seizures.
If the scanner has been operational for an extended period of time, the surface may become warm to the touch. If the
temperature becomes too warm to the touch within a minute of use, turn it o and allow it to cool.
14 Scanning Safety Planmeca Emerald User Manual
To Next Page
Loading...
Need help?
General