Planmeca PlanScan - Detailed System Settings

10 Introduction Planmeca PlanScan User Manual
Sprue Angle Method
(For mill systems)
Margin Ramp
(For design systems)
Spacer Thickness
(For design systems)
Dropper Tool
(For design systems)
Spaceball Settings
(Optional accessory)
Network Settings
This screen should be used only under the supervision of a customer service representative.
These settings are pre-congured and should not be changed.
Workbook Exercises
(For Classic systems)
Mill Notication Settings
(For Classic systems)
Milling Settings
(For mill systems)
Auto or Occlusal POI
(For mill systems)