Planmeca PlanScan - Administration; Relocating System Components; System Updates and Maintenance; Scanning Tip Management

Admi nistration
This chapter describes the administrative functions associated with the Planmeca PlanScan
System.
Relocating the Laptop and/or Scanner
The laptop can be unplugged and moved as needed. The software does not need to be shut
down. The scanner can be disconnected at any time.
System Information and Upgrades
Software and Hardware
System software and hardware upgrades are initiated through Planmeca only. Nosoftware or
hardware should be added or deleted to/from the Planmeca systems without prior approval of
Planmeca. Doing so may result in damage to the system and will void the product warranty.
Connecting the Scanning Tip
(After disinfection if scanning intraorally. See insert with scanning
tips for further details.)
1 Grasp the body of the scanner with one hand.
2 Use the other hand to press the scanning tip onto the scanner as
shown. A locking click is heard once the tip is fully seated.
Disconnecting the Scanning Tip
1 Grasp the body of the scanner with one hand.
2 With your other hand depress the green button on the
underside of the scanner. Gently pull the tip from the
scanner.
To prevent damage to the scanner, pull the pieces
apart gently and without twisting or bending.
When the scanner is not in use, place the non-functional protective scanner tip on the scanner.
(Included with the scanner during shipping.)
Note: Failure to follow this procedure can in damage to scanner and scanningtip.
10828200.B Administration 11
E4D
Planmeca
2