Planmeca Viso - Planmeca Viso Before Exposure Procedures; Preparing the X-ray System; Attaching Patient Supports

9 Before exposure
9.1 Preparing X-ray system
9.1.1 Attaching patient supports
9.1.1.1 Attaching adapter
About this task
Follow these instructions to attach the adapter to the patient support base.
Steps
1. Press the trigger down and hold.
2. Attach the adapter by sliding it into place in an upright position.
3. Release the trigger.
9.1.1.2 Removing adapter
About this task
Follow these instructions to remove the adapter.
Steps
1. Press the trigger down and hold.
2. Remove the adapter by sliding it downwards in an upright position.
9 Before exposure
User's manual Planmeca Viso 27