3.11
ENGINE
Chapter 8)
8. Front prop shaft (4x4 models) (Drive pin out at front
gearcase, pull shaft back, then forward. Refer to Drive
Chapter)
9. Remove transmission linkage rod (A) and vent hose
(B)
10. Disconnect gear indicator switch harness (at
transmission)
11. Disconnect speed sensor from transmission (left rear
side).
12. Rear fuel tank bracket
13. CVT air intake and exhaust ducts
14. Remove carburetor. Insert a clean shop towel into the
carburetor flange to prevent dirt from entering the
intake port.
15. Remove exhaust head pipe.
16. Starter motor positive (+) and negative (-) cables at
starter motor.
A
B
To Next Page
Loading...
