2. Clear the Enable Poly Content App Sharing check box.
3. Select Save.
System Allow List
The allow list enables access to your system web interface and SNMP ports only to IP addresses you
specify.
An allow list supports up to 30 addresses (including IPv4 and IPv6 formats) and can only be
configured in the system web interface.
NOTE: If your IP addresses are dynamically assigned, make sure the allow list is updated so those
hosts can connect to your system.
Add IP Addresses to the Allow List
You can add and edit specific IP addresses to an allow list for your system.
WARNING! Once you save the IP allow list, you can access the system web interface of only those
devices on the list. If your current device isn’t on the list, you can’t access the system web interface
for that device. You may have to factory restore the system to regain access.
1. In the system web interface, go to Security > Access.
2. Select Enable Allow List, then Edit Allow List.
3. Select address type IPv4 or IPv6.
4. In the IP Address field, enter the address of the system you want to add to the allow list.
5. Select Add.
6. Repeat steps 4 and 5 for the other IP addresses you want to add to the allow list.
7. Select Save.
Delete IP Addresses from the Allow List
You can delete specific IP addresses from the allot list for your system.
1. In the system web interface, go to Security > Access.
2. Select Edit Allow List.
3. Select the check box next to any IP address you want to delete and select Remove.
IPv4 Address Formats
The configuration requires a single IP address, a range of addresses, or an IP and netmask. (The
netmask represents the number of valid bits of the IPv4 address to use.)
The following are valid IPv4 formats for your G7500 and Studio X series system:
● 10.12.128.7
● 172.26.16.0/24
System Allow List
65
To Next Page
Loading...
Need help?
General
