Administrator’s Guide for Polycom HDX Systems
8–10 Polycom, Inc.
Setting Description
Allow Access to
User Settings
Specifies whether the User Settings screen is accessible to
users via the System screen.
Select this option if you want to allow users to change
limited environmental settings.
Enable Remote
Access
Specifies whether to allow remote access to the system by:
• Web
• Telnet
• SNMP
You may select any of these, or any combination of them.
Note: The system restarts if you change the remote access
settings. This setting does not deactivate the associated
port, only the application. Use Web Access Port to disable
the port.
When the Polycom HDX system is paired with a Polycom
Touch Control, web remote access must be enabled.
Web Access Port
(http)
Specifies the port to use when accessing the system using
the Polycom HDX web interface.
If you change this from the default (port 80), specify a port
number of 1025 or higher, and make sure the port is not
already in use. You will need to include the port number with
the IP address when you use the Polycom HDX web
interface to access the system. This makes unauthorized
access more difficult.
Note: The system restarts if you change the web access
port.
Allow Video
Display on Web
(local interface
only)
Specifies whether to allow viewing of the room where the
system is located, or video of calls in which the system
participates, using the Polycom HDX web interface.
Note: This feature activates both near site and far site video
displays in Web Director.
Connect to my
LAN
(local interface
only)
Specifies whether the system is part of the LAN.
Changing this setting causes the system to restart.
If Connect to my LAN is disabled, a Polycom HDX system
cannot pair with a Polycom Touch Control.
NTLM Version Specifies the authentication protocol for use with Microsoft
Office Communications Server or Microsoft Lync Server,
LDAP directory, and Polycom Converged Management
Application (CMA) or Polycom RealPresence Resource
Manager system connections. If set to Auto, the system
first tries NTLMv2, and if NTLMv2 fails it tries again with
NTLMv1.
Enable Sessions
List
Allows you to see a list of IP addresses that are logged in to
your HDX system.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
