EasyManuals Logo

Polycom RMX 1800 User Manual

Polycom RMX 1800
539 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #344 background imageLoading...
Page #344 background image
Polycom® RMX™ 1800 Administrator’s Guide
16-28 Polycom, Inc.
LAN Redundancy
LAN redundancy enables the redundant LAN port connection to automatically replace the
failed port by using another physical connection and NIC (Network Interface Card). When a
LAN port fails, IP network traffic failure is averted and network or endpoints
disconnections do not occur. When LAN redundancy is enabled, by default, LAN 1 is the
active port and LAN 2 is its backup.
Requirements
LAN redundancy is disabled by default. However, you can change its availability by setting
the LAN_REDUNDANCY system flag.
Media, Signaling and Management Redundancy
On the Polycom RMX 1800, for Media, Signaling and Management Redundancy, you must
set LAN_REDUNDANCY system flag to YES.
To enable LAN redundancy:
1 Make sure the LAN_REDUNDANCY system flag is set to YES.
LAN_REDUNDANCY is set as NO by default, and is hidden in the System Flags list.
To make sure LAN_REDUNDANCY is set as YES, do the following:
a On the RMX menu, click Setup > System Configuration > System Configuration.
The System Flags dialog box opens.
b Select MULTIPLE_SERVICES and make sure it’s value is NO. If not, click Edit
Flag and change its value to NO.
a Select LAN_REDUNDANCY and make sure it’s value is YES. If not, click Edit
Flag and change its value to YES.
If you cannot find LAN_REDUNDANCY in System Flags dialog box, click New
Flag to add it, and set its value as YES.
2 Click Close to exit the System Flags window.
3 When prompted to reset the MCU, click Yes.
Hardware Monitor Indications
When LAN Redundancy is enabled on the Collaboration Server, LAN 1 port is Active. With
LAN redundancy, when LAN LEDs are lit they indicate that a physical connection of the
You cannot enable LAN Redundancy and Multiple Network Services at the same time.
That is, if
MULTIPLE_SERVICES is set as YES in the System Flags, you must changes its value
to
NO before you can set LAN_REDUNDANCY as YES.
Download from Www.Somanuals.com. All Manuals Search And Download.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Polycom RMX 1800 and is the answer not in the manual?

Polycom RMX 1800 Specifications

General IconGeneral
BrandPolycom
ModelRMX 1800
CategoryServer
LanguageEnglish

Related product manuals