User Guide for the Polycom SoundStation IP 7000 Phone
1 - 12
Before you set up your phone to connect to a Polycom HDX system, make sure
you have the optional Video Kit (containing a Polycom HDX Microphone
Cable). You use the Polycom HDX Microphone Cable to connect your phone
to the Polycom HDX system.
When you connect your phone to a Polycom HDX system, you do not need to
connect the phone to a power source. The Polycom HDX system provides the
power source.
To connect your phone to a Polycom HDX system:
1. Connect your phone to the network:
a Connect the 25-foot Network Cable to the LAN jack on the phone.
b Connect the other end of the 25-foot Network Cable to an available
LAN port on the wall or hub/switch device port.
The following figure shows how to connect the phone to the network.
2. (Optional.) Connect an external microphone or auxiliary audio
components to your phone. See Connecting Optional External
Microphones on page 1-8 and Connecting Optional Auxiliary Audio
Components on page 1-9.
Note
You can only connect a single-phone setup to the Polycom HDX system. That is,
you cannot connect two phones together (using the Console Interconnect Cable),
and then connect the phones to a Polycom HDX system.
Note
If you are using a Multi-Interface Module, follow the steps for Connecting the Phone
Using AC Power (One Phone, with Multi-Interface Module) on page 1-5, and then
go to step 2.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
