Polycom Vortex EF2280 - DELAYOE - Enable Output Delay

F01DELAYO2?
Query current output delay on
output channel 2 .
F01DELAYO2x , where x is between 0 and 3400
depending on the current output delay setting for
output channel 2. If this command is issued after
the above example, then the status message will be
F01DELAYO23200 .
8.38. DELAYOE -- Enable Output Delay
This command sets or queries the enabled state of the output delay for each of the twelve output channels (1-8,
A-D) .
This command is a channel boolean command. See
Section 6.3 and Section 6.1 for more information on this type
of command.
This command is saved to non-volatile memory only as part of a preset. The state of this command will be
restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description Status Message
F01DELAYOE41
Enable output delay on
output 4 .
F01DELAYOE41
F01DELAYOEA0
Disable output delay
on output A .
F01DELAYOEA0
F01DELAYOE72
Toggle enabled status
of output delay on
output 7 .
F01DELAYOE7x , where x is either 0 or 1 depending
on the current enabled status of the output delay on
the output.
F01DELAYOEC?
Query enabled status
of output delay on
output C .
F01DELAYOECx , where x is either 0 or 1 depending
on the current enabled status of the output delay on
the output.
F01DELAYOE*1
Enable output delay on
all outputs (1-8, A-D) .
F01DELAYOE*111111111111
F01DELAYOE*0
Disable output delay
on all outputs (1-8, A-
D) .
F01DELAYOE*000000000000
F01DELAYOE*111111110000
Enable output delay on
outputs 1-8 and
disable output delay on
outputs A-D.
F01DELAYOE*111111110000
F01DELAYOE*2
Toggle enabled status
of output delay on all
outputs.
F01DELAYOE*abcdefghijkl , where each of the
letters (a, b, etc.) is either 0 or 1 depending of the
current enabled status of the output delay on the
corresponding output. If this command was sent after
the example above, then the status message would be
F01DELAYOE*000000001111 .
F01DELAYOE*?
Query enabled status
of output delay on all
outputs.
F01DELAYOE*abcdefghijkl , where each of the
letters (a, b, etc.) is either 0 or 1 depending of the
current enabled status of the output delay on the
corresponding output. If this command was sent after
the example above, then the status message would be
F01DELAYOE*000000001111 .