Polycom Vortex EF2280 - LAGCMIN - Set Minimum Allowed Line Input AGC Gain

This command is saved to non-volatile memory only as part of a preset. The state of this command will be
restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description Status Message
F01LAGCMAXA3
Set AGC maximum gain on input
channel A to 3 dB.
F01LAGCMAXA3
F01LAGCMAXB?
Query the AGC maximum gain on
input channel B.
F01LAGCMAXBx , where x is a number between 0
and 15, depending on the current setting of the AGC
maximum gain on input channel B.
F01LAGCMAX*6
Set AGC maximum gain on input
channels A-D to 6 dB.
F01LAGCMAX*èèèè
F01LAGCMAX*ääìì
Set AGC maximum gain on input
channels A-B to 0 dB and AGC
maximum gain on input channels
C-D to 9 dB.
F01LAGCMAX*ääìì
F01LAGCMAX*?
Query AGC maximum gain on
input channels A-D.
F01LAGCMAX*abcd , where a-d are each between ä
and É, depending on the current setting of the AGC
maximum gain for each of the four line input
channels.
8.61. LAGCMIN -- Set Minimum Allowed Line Input AGC Gain
This command sets the minimum gain that the AGC can apply on input channels A-D . For example, if LAGCMIN
is set to -10, then the AGC for that channel can apply a minimum of -10 dB of gain to the input signal.
This command was introduced in firmware version 2.5.0.
This command is a channel integer command. See
Section 6.3 and Section 6.2 for more information on this type
of command. The minimum and maximum values for this command are -15 and 0, respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command will be
restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description Status Message
F01LAGCMINA-3
Set AGC minimum gain on input
channel A to -3 dB.
F01LAGCMINA-3
F01LAGCMINB?
Query the AGC minimum gain on
input channel B.
F01LAGCMINBx , where x is a number between -15
and 0, depending on the current setting of the AGC
minimum gain on input channel B.
F01LAGCMIN*-6
Set AGC minimum gain in input
channels A-D to -6 dB.
F01LAGCMIN*~~~~
F01LAGCMIN*ääüü
Set AGC minimum gain on input
channels A-B to 0 dB and AGC
minimum gain on input channels C-
D to -3 dB.
F01LAGCMIN*ääüü
F01LAGCMIN*?
Query AGC minimum gain on input
channels A-D.
F01LAGCMIN*abcd , where a-d are each between u
and ä, depending on the current setting of the AGC
minimum gain for each of the line input channels.