Polycom Vortex EF2280 - MUTEI - Mute One or more Inputs; MUTEO - Mute One or more Outputs

F01MUTEI70
F01MUTEI80 .
8.96. MUTEI -- Mute One or More Inputs
This command sets or queries the mute status of the analog inputs (1-8, A-D) .
This command is a channel boolean command. See
Section 6.3 and Section 6.1 for more information on this type
of command.
This command is saved to non-volatile memory only as part of a preset. The state of this command will be
restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description Status Message
F01MUTEI41
Mute input 4 .
F01MUTEI41
F01MUTEIA0
Unmute input A .
F01MUTEIA0
F01MUTEI72
Toggle mute status of
input 7 .
F01MUTEI7x , where x is either 0 or 1 depending on
the current mute status of the input.
F01MUTEIC?
Query mute status of
input C .
F01MUTEICx , where x is either 0 or 1 depending on
the current mute status of the input.
F01MUTEI*1
Mute all inputs (1-8, A-D)
.
F01MUTEI*111111111111
F01MUTEI*0
Unmute all inputs (1-8, A-
D) .
F01MUTEI*000000000000
F01MUTEI*111111110000
Mute inputs 1-8 and
unmute inputs A-D.
F01MUTEI*111111110000
F01MUTEI*2
Toggle mute status of all
inputs.
F01MUTEI*abcdefghijkl , where each of the letters
(a, b, etc.) is either 0 or 1 depending of the current
status of the mute on the corresponding input. If this
command was sent after the example above, then the
status message would be F01MUTEI*111111110000
.
F01MUTEI*?
Query mute status of all
inputs.
F01MUTEI*abcdefghijkl where each of the letters
(a, b, etc.) is either 0 or 1 depending of the current
status of the mute on the corresponding input. If this
command was sent after the example above, then the
status message would be F01MUTEI*111111110000
.
8.97. MUTEO -- Mute One or More Outputs
This command sets or queries the mute status of the analog outputs (1-8, A-D) .
This command is a channel boolean command. See
Section 6.3 and Section 6.1 for more information on this type
of command.
This command is saved to non-volatile memory only as part of a preset. The state of this command will be
restored after power-up only if a preset is saved and that preset is set to be the power-on preset.