EasyManuals Logo

Precor Experience 700 Series User Manual

Precor Experience 700 Series
339 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #168 background imageLoading...
Page #168 background image
2. Reconnect the motor static bleed resistor ground wire and secure using the 5/16 " hex
head fastener. Fully tighten the fastener to ensure good electrical contact with the
frame weldment.
WARNING:Static electric shock hazard. Make sure the motor static bleed resistor
ground wire is securely connected to the frame. When the ground wire is not con-
nected, touching the motor housing could cause static charge electrical shock
and personal injury.
3. Reconnect the Motor Controller "MTH" and "MOTOR" cable connectors , see "Motor
Controller (MC) Replacement" on page123. Make sure the cable connectors have
the correct orientation and alignment before inserting into the MC I/O
1
connector.
1
Input and Output Interface.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 158
6 Replacement Procedures
Drive Motor Replacement

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Precor Experience 700 Series and is the answer not in the manual?

Precor Experience 700 Series Specifications

General IconGeneral
BrandPrecor
ModelExperience 700 Series
CategoryTreadmill
LanguageEnglish

Related product manuals