5. Secure the left/right deck front using the two #3 Phillips front deck screws and fully
tighten.
6. Reinstall the Drive Roller and Drive Belt, see "Drive Roller Replacement" on
page168.
7. Reinstall the Take-up Roller, see "Take-up Roller Replacement" on page178.
8. Center and square the running belt onto the Take-up and Drive rollers, tension the
belt to specification and verify the belt tracking, see "Running Belt Tension and Track-
ing Adjustment" on page67.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 199
6 Replacement Procedures
Running Belt and Deck Replacement Procedure
To Next Page
Loading...
