MAINTENANCE
MENU
DESCRIPTION
A belt rating of 0 or 1 will cause a blue pulsing ASL light indicating
that there is a problem with the running belt/deck and requires ser-
vicing or replacement.
Important:Reset the Belt Rating after replacing with a new run-
ning belt and deck (select Replace).
» Next Maintenance
Due
menu: Maintenance > Next Maintenance Due
Provides machine next maintenance due remaining mileage or
hours. Perform preventative maintenance when the maintenance
counter reaches 0.
Important:Reset the maintenance interval after completing
routine maintenance service, (select Reset).
Active Status Light
(1)
(ASL) menu
menu: Maintenance > Active Status Light
Indicates the machine operating and maintenance status.
Blue Solid: Normal operation Indicates that the ASL has not
detected any logged error codes.
Blue Pulsing: Preventative maintenance reminder.
• Treadmills: A belt rating of 0 or 1 will cause a blue pulsing ASL
light indicating that there is a problem with the running belt/deck
and is in need of servicing or replacement.
• ALL: The maintenance counter starts at 1000 hours counting
down to active use hours to 0 indicating preventative maintenance
is due.
Yellow Solid: Indicates an error has occurred, was self-corrected
and the machine can be used. The fault can be cleared.
Yellow Pulsing There is a current non-recoverable fault con-
dition, there is a loss of a major function and the machine id out-of-
service. Machine service is required.
» AS light Brightness
(1)
menu: Maintenance > AS Light Brightness
Range: Low, Medium, High
Set the ASL brightness level.
» Maintenance
Reminder
menu: Maintenance > Maintenance Reminder
Range: OFF, ON (default)
Switch the maintenance reminder function ON or OFF.
Notes:(1) Only used on machines that support the Active Status Light feature.
System Settings menu
System Settings menu
menu: Service menu (51765761) > Settings > System Settings.
P82 Console 53
7 Standard Service Menus
Service Menu (51765761)
To Next Page
Loading...
