System Settings Setup (Display & Workout Limits)
This procedure configures the Display and Workout Limits settings.
1. If you have a previously cloned System Settings USB drive or you can create one from
another configured machine, then import the System Settings, see "Cloning the System
Settings" on page31 and skip to "TV Channel Guide Setup" below. If not, continue pro-
cedure.
2. Verify that each of the Display settings are set to the facility settings, select System Set-
tings > Display, see "Display menu" on page54.
l Default Language (default English)
l Measurement Units (default US Standard)
l Standby Mode Delay (default 15 minutes)
3. Verify that each of the Workout Limits are set to the facility settings, select System Set-
tings > Display, see "Workout Limits menu" on page56.
l Maximum Workout Duration (default 120 minutes)
l Maximum Pause (default 30 seconds)
l Summary Time Out (default 60 seconds)
l CrossRamp Auto-Level [EFX (default 1), TRM (default 0)]
TV Channel Guide Setup
This procedure configures the TV Channel Guide
Note:This procedure assumes that the facility TV service provider has provided a
console compliant TV RF input signal.
Select one of the following methods to configure the TV Channel Guide:
1. If you have a previously cloned TV Channel Guide USB drive or you can create one
from another configured machine, then import the Channel Guide, see "Cloning the TV
Channel Guide" on page33.
2. If you cannot import an existing Chanel Guide, then use the SCAN fundtion to create a
new Channel Guide from the TV RF input signal, see "Scanning the TV Channel
Guide" on page35.
Media Adapter Console Setup
Use this procedure to setup and configure a media adapter console.
1. For media adapter setup and configuration information, see "Media Adapter Consoles"
on page38.
Verify the console operation
1. Verify console operation and return to service, see "Operation Verification" on page14.
28
4 Console Installation and Removal
Installation Procedure
To Next Page
Loading...
Need help?
General
