Precor Experience P62 - Registering the Console

Registering the Console
About
This procedure provides instructions to register the console with the PBS (Preva
®
Business
Suite) .
Note:This procedure assumes that the facility internet service provider has provided
a wired Ethernet LAN connection.
Registering the console is a two step process:
l "Console Internet Setup" below
l "Register the console" below
Console Internet Setup
menu: System Settings > Connectivity
This procedure configures the console "Wired" Ethernet LAN Network connectivity option and
assumes that the facility wired Ethernet LAN Network is working correctly (there is also a Wire-
less internet connectivity option, check with the facility operator).
1. Make sure the facility wired Ethernet LAN network is connected and operating correctly.
2. Set the Network Type parameter to Wired (select Network Type > Wired > OK).
3. Set the Configuration parameter to Automatic (select Configuration > Automatic >
OK.
4. After the console has successfully connected to the LANnetwork, the Status parameter
will change from Not Connected to Connected:
a. If the Status is Connected, continue procedure to register the console.
b. If the Status is Not Connected, make sure the Ethernet LAN cable is properly
connected and make sure the LAN network is operating.
Register the console
menu: System Settings > Connectivity
This procedure provides instruction to register the console and base with Precor PBS (Preva
®
Business Suite). The console must be connected to the internet to register the console.
1. Specify the Preva
®
Server server address, select Connectivity > Preva
®
Server and
specify the following Precor Preva
®
Server address:
Preva
®
Server address: na.preva.com
2. Select OK to save the address and return to the Connectivity menu.
3. Select Back to return to the System Settings menu.
36
5 Setup and Configuration
Registering the Console