Viewing the current ASL state
The current ASL state (solid blue, pulsing blue, solid yellow; or pulsing yellow) can be viewed
using the service menu ACTIVE STATUS LIGHT parameter.
P62, P80, and P82 consoles:
Access Club Settings (5651565) > Maintenance menu > ACTIVE STATUS LIGHT > cur-
rent ASL state.
Viewing the ASL maintenance counter remaining miles (or hours)
P62, P80, and P82 consoles:
Access Serice Software (51765761) > Maintenance menu > Next Maintenance Due
The maintenance counter shows the remaining miles (or hours) until the machine main-
tenance is due. Reaching zero triggers the ASL pulsing blue "maintenance due" state.
Clearing the Blue Pulsing ASL State (Maintenance Counter reset)
Resetting the maintenance counter clears the blue pulsing ASL state and sets the ASL state to
solid blue. The maintenance counter is also reset to the default value (treadmills reset to 1000
miles, ellipticals reset to 250 Hrs).
P62, P80, and P82 consoles:
1. Access Service Settings (51765761) > Maintenance menu.
2. Select Next Maintenance Due > Reset.
Clearing the Yellow & Yellow Pulsing ASL states
An ASL pulsing yellow state is triggered when an error code event occurs and is logged. To
clear a pulsing yellow state, the error condition causing the ASL pulsing yellow must first be
resolved either manually or the machine may resolve and self-clear the issue. A manually or
machine self-cleared error code will change the ASL state from pulsing yellow to the solid yel-
low state.
Clearing the pulsing yellow ASLstate
An ASL pulsing yellow state is triggered when an error code event occurs and is logged. To
clear a pulsing yellow state, the error condition causing the ASL pulsing yellow must first be
resolved either manually or the machine may resolve and self-clear the issue. A manually or
machine self-cleared error code will change the ASL state from pulsing yellow to the solid yel-
low state.
76
9 Troubleshooting
Active Status Light (ASL)
To Next Page
Loading...
