PREVOST H3-41 - Dashboard Controls and Lighting

CONTROLS AND INSTRUMENTS
The DDR receptacle is located inside the footwell,
on the upper left side wall.
CONTROL SWITCHES
High quality laser-engraved switches are used to
control many of the features of the vehicle. Many
switches have an embedded indicator LED to
inform the driver at a glance which features are
active. Some switches' LED will turn OFF after a
short while when the engine is running. This is
normal and is designed to reduce glare when
driving. The functions still operate even if the LED
is OFF. If the switches are still ON when the
engine is turned OFF, the LEDs will illuminate to
warn the driver to turn them OFF. Switches are
described in the order they appear, from left to
right, top to bottom.
L.H. DASHBOARD PANEL
Option
Retarder
Option
Engine brake
Option
Kneeling
Option
Hi Buoy
L.H. DASHBOARD PANEL 06347
The dashboard is designed with driver-exclusive
controls at the left side, and controls, for
passenger comfort and entertainment on the right
side of the dashboard.
Headlights
06254
Press
rocker switch to the first
position to activate clearance,
tail and marker lights. Push
down fully to turn ON
both the
clearance and marker lights and
the headlights. The controls and
instrument lights will illuminate.
Note: Daytime running lights
will be
automatically cancelled when the exterior
lighting switch is fully depressed.
Fog Lights
06255
Optional halogen fog lights
provide better visibility in fog and
precipitation. They improve
close range visibility and provide
added safety. Remove
protective covers from fog lights
before use.
Warning: Turn OFF engine and apply parking
brake before removing fog light covers.
Note: Some states and provinces restrict the
use of fog lights
. Verify local state or provincial
regulations before using.
Hazard Warning Flashers
06256
Press the rocker switch to make
all turn signal
lights flash at
once. The dashboard telltale
lights will flash when the hazard
warning flashers are ON.
Caution: Do not use the hazard flashers
for an
extended period of time unless necessary
because the electrical circuits are activated
when the hazard switch is depressed.
Upper Windshield Wipers
06257
Press the rock
er switch to the
first position to activate the
upper wipers intermittently.
Press to the second position for
continuous operation of the
upper wipers.
Caution: To avoid damaging the wiper blades
or scratching the windshield, do not operate the
wipers when the windshield is dry. Also, loosen
frozen wipers before operating.
31